Veterynarna biotehnologija – Veterinary biotechnology, 2020, 37, 44-50 [in Ukrainian]. https://doi.org/10.31073/vet_biotech37-05
KOSTIUK M.V., е-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
State Scientific and Research Institute of Laboratory Diagnostics and Veterinary and Sanitary Expertise
ZASTULKA O.O., е-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
State Service of Ukraine on Food Safety and Consumer Protection
GALATIUK O.E., е-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Zhytomyr National Agroecological University
ANALYSIS OF BEE WAX QUALITY INDICATORS IN 2016-2018
Introduction. Beeswax is a substance produced by the wax glands of bees and released in the form of the thinnest plates. Given the wide field of its use, the control of wax quality indicators plays an important role in obtaining high quality products in the future.
The goal of the work. To determine the level of adulteration and quality of beeswax samples received for testing in State Research Institute for Laboratory Diagnostics and Veterinary Sanitary Expertize during 2016-2018.
Materials and methods. Data analysis was performed based on the results of studies of beeswax on quality indicators – mass fraction of water, melting point, density, duration of immersion of the needle Vika, the presence of adulterated impurities that were tested in 2016-2018. During this period, 142 samples were examined. The research was carried out according to DSTU 4229: 2003 "Bee apiary wax". Specifications.
Results of research and discussion. Comparative analysis of the data indicates that there is no clear dynamics of increase or decrease in the number of samples with excess of acceptable levels of quality indicators. In general, we can say that the percentage of samples that exceed the MPL by quality parameters is quite high and ranges from 3 to 38% of the total number of tests
Conclusions and prospects for further research. It is established that 35% of 142 samples of beeswax studied in 2016-2018, exceeded the maximum permissible levels (MPL). According to the indicators, the mass fraction of water and the duration of immersion of the Vick needle deviation of the obtained results from the MPL was over 20%, and in some cases exceeded 50%. We will continue routine monitoring of beeswax quality control, given the wide field of its application in various industries.
Keywords: wax, beekeeping products, quality indicators, mass fraction of water, melting point, density, duration of immersion of the Vika needle, adulterating impurities.
REFERENCES